Steps For Installation Of Cladding On An External Wall

External wall cladding is the layering of non-structural material over the outer surface of a building’s walls in architecture. When we look at the surface of a completed structure, we frequently find a covering of the same structural material employed in its construction. External wall cladding is a cover material that is used on the outside of buildings.

There are many types of cladding available in the market, each with its own set of characteristics, like cost, appeal, lifetime, upkeep, durability, and suitability for a particular environment. As a result, cladding should not be chosen simply on the basis of appearance but also based on the environment in which it will be put.

Exterior and interior grade cladding both have distinct characteristics. Therefore the choice should be made depending on the planned use while installing external wall cladding.

Tips for installing external wall cladding:

  • Add 5% extra material for waste while designing your project.
  • On the outside wall, use a breathable waterproof membrane for external wall cladding.
  • When using screws and plugs to install the batten centres, make sure they are no more than 600 mm apart.
  • Double up on joists if necessary to accommodate the joints throughout the cladding.
  • When placing the first row of fasteners, use the chalk line to keep them even, and make sure the cladding is at least 2 cm off the ground.
  • Use concealed clip fasteners for a quick and secure installation with a beautiful finish that hides the screws.
  • Allow for growth by leaving a proper space at the butt joints.
  • Use a straight board to guide your circular saw while cutting the top edge of the cladding to size. This will give your cladding a sharper edge and a smooth, high-quality finish.

Step 1: If your wall is plastered and painted, use an angle grinder to carve grooves into it (horizontally and vertically). Then chip off portions of the paint and plaster with a chisel and hammer. This will allow the mortar to adhere to the wall properly. You should end up with something like this on your wall.

Step 2: To obtain the correct quantity of material for your walls, you’ll need to measure the length and breadth of your exterior before installing any external wall cladding. Other dimensions, such as the size of gaps surrounding windows and doors, will be needed for any trims or channels.

Step 3: Before you put any cladding on the outside of your house, make sure all of the plywood sheathings are in place.

Step 4: Wrap your house with your preferred house wrap and staple it in place. After that, secure the foam insulation panels with nails. These components are critical to your home’s ultimate energy efficiency and weather protection.

Step 5: Starting at the bottom of the wall, it’s crucial to take your time here because it’ll be the basis for the rest of your cladding. Maintain the initial row’s level over its full length so that each subsequent row is also straight.

Step 6: If you’re using cement board, vinyl siding, or metal siding, remember that each row must overlap the top of the previous row. This is to prevent water from sliding down the cladding’s backside. A declination line will be available on most items to assist you.

Step 7: Now that the wall is finished, add the trimmings, corner pieces, and finishing touches. The channels must be put first, but the trim and corner pieces are added after the wall siding has been installed.

Wall cladding is a very useful decorative material that may be used both indoors and outdoors to bring more originality to your house or structure.

Leave a Reply

Your email address will not be published. Required fields are marked *

Eweniversally Green